Embedded Basic - Arduino
Design Overview
The Arduino UNO in this circuit has the following pin connections and purposes:
- D2: Connected to the DOUT pin of the DHT11 Temperature-Humidity sensor module.
- D4: Connected to the D7 pin of the LCD 16x2 display.
- D5: Connected to th[...]
Design Overview
The Arduino UNO in this circuit has the following pin connections and purposes:
- D2: Connected to the Digital Output (DO) pin of the Flame Sensor. This pin will read the digital signal from the flame sensor.
- D3: Connected to one end of a 33[...]
Design Overview
The Arduino UNO in this circuit has the following pin connections and purposes:
- GND: Connected to leg1 of the Trimmer Potentiometer, providing a ground reference.
- 5V: Connected to leg2 of the Trimmer Potentiometer, supplying a 5V power sou[...]
Design Overview
The Arduino UNO in this circuit has the following pin connections and purposes:
- D2: Connected to the "out" pin of the IR sensor. This pin is likely used to read the output signal from the IR sensor.
- GND: Connected to the ground pins of the[...]
Design Overview
The Arduino UNO in this circuit has the following pin connections and purposes:
- D7: Connected to the D4 pin of the LCD 16x2 display.
- D6: Connected to the D5 pin of the LCD 16x2 display.
- D5: Connected to the D6 pin of the LCD 16x2 d[...]
Design Overview
The Arduino UNO in this circuit has the following pin connections and purposes:
- D2: Connected to the SIG pin of the PIR sensor. This pin will read the signal from the PIR sensor to detect motion.
- D3: Connected to one end of a 330 Ohm resis[...]
